ASSEMBLY GUIDE

Step 1

Carefully unpack the logo and assembly template. Place it with the front facing down on a soft surface such as bubble wrap.

step 2

Pull off the protective tape that is mounted on the back of the logo.

Step 3

Lift the mounting template away from the letters.

volodymyr-hryshchenko-tGFh1y_fSH0-unspla

Step 4

Measure the location of the logo on the wall and temporarily attach the mounting template with a couple of pieces of masking tape. Check that the template is horizontal using a spirit level.

Step 5

Apply mounting glue to the back of the first letter. We permanent assembly lay whole glue strings. When mounting outdoors, it is important that you do not create rain traps from the glue strings but leave an opening along the bottom that any rain can pass.

Step 6

If the logo is only to be mounted temporarily, for example at a trade fair, then apply only small "glue dots" when the logo is cornered. After use, the logo can usually be dismantled without damage by cutting off the glue piece with a folding blade knife with a well-cut blade. The logo is then placed in the assembly template, which also becomes a transport and storage protection.

Step 7

Place the letter in its place in the mounting template.

Step 8

Press the letter against the wall with a light pressure. NOTE! Do NOT use your palms your thumbs (the point load gives pressure marks on the surface).

Step 9

When the glue has hardened, lift off the mounting template with care. Do not pry against the letters.

And

The assembly is now complete!